Using the Configurator

The configurator guides you through the product setup in a fixed order. Earlier steps control what is possible later on.

Step 1: Dimensions

Enter the opening width and height first. This sets the overall size the rest of the layout must fit into.

Use Measuring and Dimensions if you need help with size entry.

The layout step lets you drag the separators between sections to change proportions.

Important points:

you are adjusting the balance between sections, not the total size
separators stop moving when a section reaches its allowed minimum or maximum size
the default layout is the supplier's starting point

Some templates show a sections step. At the moment, this step can be limited depending on how the supplier has configured the product.

If you see a message that section options are not available yet, continue to the next step.

This step usually covers inside and outside colors or other finish choices.

Inside and outside refer to the product faces, not to separate products. Availability depends on what the supplier has configured.

This step contains selectable upgrades and feature choices such as:

Some option groups are single-choice. Others allow multiple selections.

The review step summarizes:

If you see an estimated or indicative price, treat it as a live estimate rather than a signed commercial offer.

The final step collects your contact details so the supplier can respond.

You will need to enter:

The preview shows the current layout as you work. Use it to confirm that:

the configurator is not a full CAD tool
some templates have placeholder or minimal section behavior
your configuration is not guaranteed to autosave if you leave the page before submitting